Lower the handbrake to release the pressure on the mounting (make sure you are in gear) and undo the two 14mm nuts to remove the handbrake. Lift the lower handbrake cover up off the pins on the driver's seat and slide it out over the handbrake lever. Pull the handle cover forward sharply to slide it off. Lever the clip under the lever with a flathead tool. How to remove the handbrake lever and covers from a T6 Now you need to detach the handbrake from the seat. To remove the seat and base, wiggle off the same seat belt buckle wire's clip from the bottom of the rail. ![]() Disconnect your battery, remove 4 screws that hold the seat down to your car. Now, if you want to remove the seat from the base, undo the four bolts on top of the rails (slide the seat forward and back to access them) and the seat lifts away. T5 Seat Swivel Plate (Fits either driver or passenger side). ![]() I had removed the passenger seat first, which helps with access but isn't necessary.ĭisconnect the seat belt latch sensor (I assume that's what it is) and slide the wire clip off the underside of the seat (top right).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |